Fresh start, using JT's tool. https://git.cnckloon.nl/Ton/Mesa_2019/wiki
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
 
 

29 lines
1.1 KiB

# Place any HAL commands in this file that you want to run AFTER the GUI finishes loading.
# GUI HAL pins are not visible until after the GUI loads.
# This file will not be written over by the configuration tool.
# create a signal for the estop loopback
##net estop-loop hm2_7i96.0.ssr.00.out-01
##net estop-loop iocontrol.0.user-enable-out => iocontrol.0.emc-enable-in
##net estop-ext <= hm2_7i96.0.gpio.010.in
# external estop
loadrt estop_latch
addf estop-latch.0 servo-thread
net estop-loopout iocontrol.0.emc-enable-in <= estop-latch.0.ok-out
net estop-loopin iocontrol.0.user-enable-out => estop-latch.0.ok-in
net estop-reset iocontrol.0.user-request-enable => estop-latch.0.reset
net remote-estop estop-latch.0.fault-in <= hm2_7i96.0.gpio.010.in
net estop-loop hm2_7i96.0.ssr.00.out-01
# create signals for tool loading loopback
#net tool-prep-loop iocontrol.0.tool-prepare => iocontrol.0.tool-prepared
#net tool-change-loop iocontrol.0.tool-change => iocontrol.0.tool-changed
net tooloffset-x gmoccapy.tooloffset-x <= motion.tooloffset.x
net tooloffset-z gmoccapy.tooloffset-z <= motion.tooloffset.z